With advanced industrial technology, many large industrial equipment
is already entered our lives, metaphor is now a lot of hotel, hospital, school
configured with its own laundry.Configuration in the laundry room are large
industrial washing equipment.Guangzhou ENEJEAN wash equipment manufacturing
experts today will share with you about the operation of the large washing
equipment maintenance knowledge, focus on today about dehydrator belt tightness
of debugging problems.
Dewatering machine is the main component of the tank, the
tank cloth have holes all round, be dehydrated clothes is put in the tank.Motor
through a belt drive the bladder at high speed.So much of the centrifugal
force, moisture so through the small hole of the tank will be left out, is
collected after unification.In general, for the wet clothes, the drying effect
of dewatering machine work two minutes are reaching almost work 20 minutes to
achieve the same effect with the dryer, however, dehydrator can
not completely dry clothes.So, a
kind of practice is to save time and energy, for the wet clothes to dehydration,
drying operation after take off the water.
Dewatering machine is provided by the motor through a belt transmission, is the power of the new belt is generally more tight, so the transmission torque is large, when used after a period of time, there are some loose belt, will be between the pulley and sliding, mechanical force drops, so big transmission torque without original, need of tension, of course, before the masses of users in the use of various kinds of washing equipment, should read the equipment operation instruction
1, when the optional new belt, in order to make the belt force uniform, attention should be paid to the triangle deserves to try to a small group of tolerance and the length of the belt to small.(as far as possible to keep the belt length in the same group consistency)
2, in the process of belt tension, to ensure the belt wheel axis parallel to each other, each pulley V groove corresponding to the symmetry plane should overlap, the error must not exceed 20 .
3, weekly pay attention to check the belt tension and abrasion, do it in a timely manner to adjust and change.
4, replace belt, want to dispatch center distance to a minimum, not forced into.
Dewatering machine is provided by the motor through a belt transmission, is the power of the new belt is generally more tight, so the transmission torque is large, when used after a period of time, there are some loose belt, will be between the pulley and sliding, mechanical force drops, so big transmission torque without original, need of tension, of course, before the masses of users in the use of various kinds of washing equipment, should read the equipment operation instruction
1, when the optional new belt, in order to make the belt force uniform, attention should be paid to the triangle deserves to try to a small group of tolerance and the length of the belt to small.(as far as possible to keep the belt length in the same group consistency)
2, in the process of belt tension, to ensure the belt wheel axis parallel to each other, each pulley V groove corresponding to the symmetry plane should overlap, the error must not exceed 20 .
3, weekly pay attention to check the belt tension and abrasion, do it in a timely manner to adjust and change.
4, replace belt, want to dispatch center distance to a minimum, not forced into.
没有评论:
发表评论